|
RECOMMENDED BY THE BEAR
TRAP GUIDE
How It
Works
COMMERCIAL TESTIMONIALS
Since using the Syntek product
we have not had any failures in injector pumps or injectors. We
use generators in pre-Olympic events and TV sporting events. In
the 2002 Winter Olympics we were using 875 gallons of diesel fuel
per day and after using the Syntek product our fuel consumption
dropped to 675 gallons of fuel per day. We have had generators
come to us form other parts of the country that were not running
real well. We added a double dose of the Syntek product and
within several hours the generators began running smoother. This
is a great product that I recommend to everyone.
Dave P.
GE Rentals – Salt Lake City, UT
Using Syntek Engine Boost has
lowered our fuel consumption greatly, in fact, by 15% per year – a
significant savings. My biggest savings, that was unexpected,
came in the form of labor costs. Buses get extremely black on the
rear door from diesel residue. To remove the black, we were
spending $14.50 per week per bus for cleaning ($7.25 per hour per
driver times 2 washes per week) or approximately $106,000.00 per
year. Since using Syntek Engine Boost, we only need to wash the
buses once every other month. This has created a saving in excess
of $95,000.00 per year.
Supervisor – Vehicle
Maintenance
School District of Florida
We decided to do a test on the
fuel consumption between the trucking side and construction side
of our company. The test result using Syntek were shocking, doing
the same amount of work load if not more, we purchased 15% less
fuel than the previous months. Our trucks were topping the “Three
Sisters” hills on I-80 with 2 more gears than ever before and the
trucks went from 5.6 miles per gallon to 7.2 miles per gallon
after just one month.
Bill
Oilfield Service – Wyoming
Piston No. 2 was overhauled by
the crew during dry docking. The total running hours since last
overhaul was 11,253. The total running hour on the piston was
17,318.
The following was observed:
All rings were moving freely and were in good condition.
No carbon deposits below first ring.
Combustion space was remarkably clean and tops of piston
crown were dry.
The service engineer stated
that he had never seen a piston and rings in such a good condition
after more the 11,000 hours and suggested that we should increase
the maintenance interval by using the combustion catalyst, burn
rate modifier and lubricant (Synteck Engine Boost 2.0). We have
observed 40-50% less soot and 30% less sludge. Another side
effect is less emissions and hence a cleaner environment which is
increasingly focused on today.
RL Shipping
Texas
COMMERCIAL TESTIMONIALS
I own a 2000 PeterBilt 379
with a 550 hp Cat. I have been disappointed in the average fuel
mileage of 4.7 mpg. Since using the Syntek Engine Boost 2.0
product my mileage has increased to between 5.7 and 6.2 mpg.
Being an owner-operator, the rising cost of fuel reduces profits.
This product is saving me $$ every day.
Chuck
Jacksonville, FL
When using Syntek Engine
Boost 2.0 in our large trucks we have experienced fuel mileage
increases from .5 up to 1.5 mpg. At a time when fuel prices are
going higher and higher, this is critical to the trucking
industry.
In addition, I used a sample
of the Syntek product in my leaf blower and the smoke cleared up
and it starts better.
Bill
General Manager
Historical fuel data tests
conducted at Sunshine:
First, a miles per gallon
baseline was compiled, then the Syntek product was introduced into
the #2 diesel storage tanks. Both the miles per gallon and
gallons per hour were recorded. An average overall increase in
miles per gallon of 14.1% was obtained. The other major concern
is regarding environmental issues. We are pleased to state that
Syntek provides the safest, most cost effective pollution control
technology available.
Sunshine
RESIDENTIAL TESTIMONIALS
Since my first use of Syntek
Engine Boost 2.0, I have been getting an extra 60 miles per tank!
Syntek Engine Boost is saving my wife and I over $10.00 with every
fill up. I would recommend using the Engine Boost to anyone.
James
M.
Salt Lake City, UT
I have been using the Syntek
fuel additive in my 1999 Dodge D350 truck in the last three tanks
of fuel. The fuel mileage has increased by 2 mpg and the
performance has also improved. I would highly recommend this
product to anyone who is fuel conscious and wants to increase
performance of the vehicle.
Tony G.
Idaho Falls, ID
I have a 1991 Honda Accord
sedan with 300,000 miles on the odometer. I am a traveling sales
guy living in Los Angeles. I think this car has one of world’s
most efficient engines. I take very good of the car; using only 89
Octane gasoline and maintain the engine religiously. Over the past
100K miles, I began to notice a dropping in MPG from 28-32 MPG
down to 22-24 MPG. I have since used three half oz treatments of
Syntek. I am amazed to report that I am back at 26-28 MPG. Again,
I have not altered any driving pattern. Like everyone in LA, I am
stuck in traffic half of the time while I am in the car. I am not
a scientist, but I do keep a detailed record on all of the
gasoline purchased and the mileage. I am saving over 12% on my MPG
and another .10 cents per gallon at the pump because I now can use
87 Octane with the same results as 89. This is an amazing
product!
Alex
L.
Los Angeles, CA
I have been driving a
Trailblazer for over 4 years and never once has my mileage gone
over 300 miles per tank. After using Syntek Engine Boost my
mileage jumped up to 365 per tank. I have even gotten up to as
high as 445 mpg on highway driving. This increase in mileage and
the ability to use the lower cost octane saves me an average of
$13.00 per fill up. I got my family and friends to also use
Syntek and they are experiencing similar results.
Mary
N.
Sandy, UT
I have a Ford F-150 2004
Pickup...I drove three weeks ago to California and got 13.6
MPG....added 1 oz Syntek at the fill up and got 16.6 MPG on the
way back to Mesa....next fill up drove to Casa Grande and return
and got 18.1 MPG...Went to Albuquerque NM from Phoenix last week
and got 16.6 MPG but went over two 7000 foot plus passes....on
the way back got 22.7 MPG.......My last fill up which was today
from Mesa AZ to Casa Grande and Return....got 20.8....I have a
pickup that went from 13.6 to now average of 19.5 This is a true
testimonial...I would not market this product and I told my
daughter so unless it absolutely works.....It's actually much
better than I thought it would be...as a matter of fact I am
totally amazed at the results!
Joe P.
Mesa AZ
9 Months ago he put the truck
on a Dina Flo machine and adjusted the computer to match the
torque of 88 octane to the transmission, to reset the computer to
gain the maximum power and torque between the engine and
transmission and the 88 octane fuel. He went from 12.5 to 14.6 in
added mpg and it cost him $300 ....Using Syntek he went from 14.6
to 19.3 on his third tank of gas...It took him 6 months to regain
his investment on the Dina Flo. He absolutely loves the product
and so does his truck!
Gary J.
Jackson Hole, WY
I have been using Syntek
Engine Boost 2.0 for my last four fill ups. I have upgraded my mpg
from 20.2 to 26.3. What's even better, my car is running with the
power it had when I purchased it 5 years ago. I would definitely
recommend Syntek Engine Boost to all my friends
Marissa S.
Glendale, AZ
How
It Works
|
